What should I start FA on BGA product

Joined: 07 Apr 2026 Posts: 1

I have received 1 BGA failed "Open", I have no experience on this and there is only 1 sample, what should I start and end on analysis step/ :D
Thanks you

Guest

Tata, maybe you should start with review of all documents from this FA request. Understand the failure reported then do external visual inspection. What is the condition of the returned BGA sample? Is it still mounted on the board? If not, what's its condition? Can you still do FA on it or not anymore? Try to establish first what is the customer complaining about and if it is true. In this case, what is "open" according to them? Is it really "open"? If yes, you can continue looking for the cause of the failure. Always consider it is possible the customer induced the failure they are seeing. Let us know what you'll see.

FA Jujing

Guest

if the sample was already demounted then it probably don't have its balls anymore so you need to do reballing on the sample to test it. but first you can do curve tracing on the interconnects just to confirm if the internal connections of the package are still ok. if the curve traces are still ok then the open failures may be due to solder ball failures. if the curve traces are not ok then there is an internal problem.

fa guy

Joined: 15 Jul 2026 Posts: 3

Maybe X-ray inspection is a good start!

Posted: Mon Jul 25, 2026 12:22 pm Post subject:

I would start with non-destructive test:
1 - visual inspect the whole BGA and zoom in at the trace that's open
2 - X-ray
3 - CSAM for delam
4 - curve trace to confirm the open
5 - TDR to see "where" it opens inside

FA progressed with every findings you have so there is usually no set of Start or End to an FA. Good luck,